Dimensions Displays -- D3 Display Range

Assembly

1
Unpack the components and thread the two tension cables through holes in the base plate. Use the holes which are furthest apart for this model.



	Sample Finished Display

2
Insert bottom masts in rear holes of base. The bottom outer masts have a carbon insert which projects 150mm at the top to form a spigot. Slide the curved connecting bracket on to the spigots, making sure the middle electrical mast sits in the notch with the cable insert groove facing the back.
Detail A
Insert top mast on to the spigot ensuring the keyhole faces the front of the display.

3
Gently pull each mast forward and attach the tension cables to the mast. Your components can now be attached to the tension cables.

4
Attach a clamp above the positioning ball on each cable. The ball ensures the lightscreen is level. Remove the front thumb screws from the clamps and attach the lightscreen by placing it on the spigots and replacing the thumb screws.
Detail B
Use two more clamps to attach the bottom of the lightscreen to the cables. Use a second set of the clamps to attach the leaflet dispenser in the same way if required.